Instructions
Implement a 2 x 1
Multiplexer using logic gates
- Click on components on the left side to add them to the circuit board.
- Drag and drop components to move them around, connect them using wires by dragging your
cursor from one endpoint to another.
- You can delete components by right clicking on them and selecting the delete option.
- You can set the input bits, which are by default 1, to any values of your choice for
testing, by clicking on them. Each click toggles the bit between 1 and 0.
- A single output point can drive several inputs: drag a new wire from an output point that
is already connected to connect it to another component.
- To delete a wire, right click on it and select the delete option.
- Click on the "Simulate" button after setting the input bits as per your choice. This
will simulate the circuit you built for the input bits set and will change the output
bit values accordingly, for you to test your circuit.
- Click on the "Submit" button to submit the circuit once you think you have built the
required circuit.
- Clicking on "Submit" will display a "Success" or "Failure" message in the Observations
Section according to the correctness of your circuit. It will also display a Truth Table
verifying your circuit for all input values. The truth table is shown only when every
component is connected.